The household iron guide
Your iron.
Our attitude.
Four steps. One very good decision.
Test first, then give your tee the MB treatment.
Free in every order
1 test patch + 1 pressing sheet.
Two sheets.
Different jobs.
Clear carrier filmAlready attached to your design. Keep it on for the first press. Peel it off in step 3.
Pressing sheetThe separate parchment paper in your order. It goes between the iron and design for both presses.
Let’s make it yours.
Follow in order: 1 → 2 → 3 → 4
1. Position
Clear film stays on
Lay your garment flat on a firm, heat-safe surface. Position the design printed side down, clear carrier film on top.
Keep the clear film attached. Secure its edges with heat-resistant tape, then cover the transfer with your pressing sheet.

2. Press
About 12 seconds per section · firm pressure
Press firmly with your fully heated iron. Use small circular motions and keep the pressing sheet between the iron and transfer.
Work in overlapping sections for a design larger than your iron. Give each section about 12 seconds, including the edges.

3. Peel
Wait a few seconds · peel slowly
Remove the iron and pressing sheet. Wait a few seconds, then slowly peel off the clear carrier film.
If any design lifts, stop. Lay the film back down, cover with the pressing sheet and press that area again for 10 to 15 seconds before peeling.

4. Finish press
15 seconds · clear film removed
With the clear carrier completely removed, cover the design with the pressing sheet again.
Press firmly for 15 seconds, covering the whole design. This helps it bond and feel softer. Remove the sheet and let the garment cool before wearing.
Keep the attitude. Keep the finish.
Wear it. Love it. Wash it right.
Wash inside out on a cold cycle with mild detergent. Skip bleach and fabric softener. Hang dry or tumble low. Never iron directly on the print. Follow your garment’s care label too.
Using a heat press instead?
For heat-safe cotton, use 310°F (155°C), medium-high pressure and about 12 seconds. Test first. Peel the clear film after a few seconds, then cover with the pressing sheet and finish press for 15 seconds. Other fabrics may need different settings; contact us if you’re unsure.
An edge is lifting. Now what?
Stop peeling. Lay the clear film back down, cover with the pressing sheet and press the lifting area for 10 to 15 seconds with firm pressure. Make sure the corners get heat too. If the fabric discolors, stop and do not press your main design. Email us for help.